Deflection of Rectangular Laminated Composite Plates using Dynamic Relaxation Methodصورة كتاب

اسم الكتاب

Deflection of Rectangular Laminated Composite Plates using Dynamic Relaxation Method

القسم

ركن الهندسة المدنية والمعمارية - Civil and architecture

عن الكتاب

A Dynamic relaxation (DR) program based on finite differences has been developed for small and large deflection analysis of rectangular laminated plates using first order shear deformation theory (FSDT). The displacements are assumed linear through the thickness of the plate. Dynamic Relaxation (DR) method is presented for the geometrically linear and nonlinear laterally loaded, rectangular laminated plates. The analysis uses the Mindlin plate theory with first order shear deformation theory (FSDT) which accounts for transverse shear deformation. A computer program has been compiled using a FORTRAN program. The convergence and accuracy of the DR solutions for elastic small and large deflection response are established by comparison with various exact and approximate solutions. New numerical results are generated for uniformly loaded square laminated plates which serve to quantify the effects of shear deformation, material anisotropy, fiber orientation, and coupling between bending and stretching.
It was found that linear analysis seriously over-predicts deflections of plates. The shear deflection depends greatly on a number of factors such as length/ thickness ratio, degree of anisotropy and number of layers. It was also found that coupling between bending and stretching can increase or decrease the bending stiffness of a laminate depending on whether it is positive or negative.
It was also found that: The convergence and accuracy of the DR solution is dependent on several factors including boundary conditions, mesh size and type, fictitious densities, damping coefficients, time increment and applied load. Also, the DR large deflection program using uniform finite differences meshes can be employed in the analysis of different thicknesses for isotropic, orthotropic or laminated plates under uniform loads. All the comparison results for simply supported (SS4) edge conditions showed that deflection is almost dependent on the direction of the applied load or the arrangement of the layers

صاحب الكتاب

عدد القراء

1

عدد مرات التحميل

1

التقييم

تاريخ الأضافة

2018-05-1910:44 PM

نوع الملف

application / pdf

حجم الكتاب

1812050

التعليقات

{{ comment.created_at }}

{{ whoCommented(comment) }}

{{ comment.comment }}

{{ reply.created_at }}

{{ whoCommented(reply) }}

{{ reply.comment }}

لا توجد تعليقات

Top